Behavior and process of background signal formation of hydrogen,carbon, nitrogen,and oxygen in silicon wafers during depth profiling using dual-beam TOF-SIMS

The behavior and mechanism of background signals during depth profiling of atmospheric elements using dual-beam time-of-flight secondary ion mass spectrometry (TOF-SIMS) have been experimentally investigated for silicon wafers. The background signals of atmospheric elements were found to be inversely proportional to the sputtering rate. Most of the background signals are largely attributable to the accumulation of components through adsorption and ion bombardment in the pre-equilibrium state. On the other hand, the contribution of real-time adsorption during the instant after the last sputtering in the equilibrium state is negligible under the present experimental conditions. H₂O is dominant in the background formation process of hydrogen and oxygen, which is supported by the higher adsorption coefficients. The background levels of carbon and nitrogen are lower than those of hydrogen and oxygen. Furthermore, the background signal of carbon with respect to the sputtering rate shows a different trend than the other elements. This could be attributed to accumulation in the pre-equilibrium state. These results indicate that the background levels can be lowered close to those of dynamic-SIMS by using an extremely high sputtering rate in dual-beam TOF-SIMS.     

一种通过梯形PPMgLN波导倍频实现带宽可调谐光源的理论研究

本文设计了一种梯形的周期极化掺镁铌酸锂(PPMgLN)波导,并通过在传播方向上引入温度梯度来拓宽其倍频(SHG)过程的泵浦光源可接收带宽。通过有限差分的光束传输法,计算波导的有效折射率,并进行波导尺寸的设计。结果表明,通过改变梯形波导不同位置的温度,使其形成一个温度梯度,可拓宽泵浦光源的波长可接收带宽。本文所设计的PPMgLN波导最大泵浦光源可接收带宽为C波段,即1 530~1 565 nm,该波导可倍频C波段,得到输出波段带宽为765~782.5 nm,温度调谐范围为30~150 ℃。     

Group mobility assisted network selection framework in 5G vehicular cognitive radio networks

The heterogeneity nature of networks is the most eminent characteristic in 5G vehicular cognitive radio networks across complex radio environments. Since multiple communicating radios may be in motion at the same time in a vehicle. So, group mobility is the most prominent characteristic that requires to be a deep investigation. Therefore, different communication radios that are moving on a train/bus needed to select the networks simultaneously. Without considering the group mobility feature, there is a possibility that the same network may be selected by each moving node and cause congestion in a particular network. To overcome this problem, a novel network selection technique considering the group mobility feature is proposed to improve the throughput of the network. In this work, a 5G vehicular cognitive radio network scenario is also realized using USRP-2954 and LabVIEW communications system design suite testbed. The performance metrics like transmission delay, packet loss rate, reject rate and, channel utilization for vehicular nodes, are gained to analyze the proposed technique in vehicular cognitive radio networks environment. The proposed technique demonstrates a remarkable improvement in channel utilization for vehicular nodes and outperformed conventional schemes.     

光纤基底TiNi形状记忆合金薄膜制备工艺

将TiNi基记忆合金薄膜与光纤相结合可制成智能化、集成化且成本经济的微机电系统和微传感器件.本文采用磁控溅射法在二氧化硅光纤基底上制备TiNi记忆合金薄膜,系统讨论了溅射工艺参数以及后续退火处理对薄膜质量的影响.采用自研制光纤镀膜掩膜装置在直径为125μm的光纤圆周表面上形成均匀薄膜.实验表明:在靶基距、背底真空度、Ar气流量和溅射时间一定的条件下,溅射功率存在最佳值;溅射压强较大时,薄膜沉积速率较低,但薄膜表面粗糙度较小.进行退火处理后,薄膜形成较良好的晶体结构,Ti_49.09Ni_50.91薄膜中马氏体B19′相和奥氏体B2相共存,但以B19′为主.根据本文研究结果,在玻璃光纤基底上制备高质量的TiNi基记忆合金薄膜是可实现的,本工作为下一步研制微机电系统和微型传感器做了基础准备.     

Effect of thickness variations of lithium niobate on insulator waveguide on the frequency spectrum of spontaneous parametric down-conversion

We study the effect of waveguide thickness variations on the frequency spectrum of spontaneous parametric down-conversion in the periodically-poled lithium niobate on insulator (LNOI) waveguide. We analyze several variation models and our simulation results show that thickness variations in several nanometers can induce distinct effects on the central peak of the spectrum, such as narrowing, broadening, and splitting. We also prove that the effects of positive and negative variations can be canceled and thus lead to a variation-robust feature and an ultra-broad bandwidth. Our study may promote the development of on-chip photon sources in the LNOI platform, as well as opens up a way to engineer photon frequency state.     

Highly stable dielectric frequency response of chemically synthesized Mn-substituted ZnFe2O4

The tenacity of the present study was to develop a material using an economical chemical route, having balance between magnetic and dielectric order parameters for maximum transmittance of electromagnetic waves in order to use them in shielding materials. In this context, Mn-Zn ferrites were prepared using a wet chemical based sol-gel auto-combustion technique. X-ray diffraction confirmed the pure phase formation of samples, while some impurity peaks were also present for the higher value of Mn substitution. Field emission scanning electron microscopy revealed a decrease in grain size with increasing Mn substitution. While energy dispersive X-ray spectroscopy confirmed the elemental composition of pure and Mn substituted samples, the dielectric constant, dielectric loss and tangent loss were decreased with increasing frequency and increasing Mn substitution. The complex electric modulus was found to be a function of frequency and values of complex electric modulus were increased with increasing frequency and Mn substitution. The complex impedance of RC series circuit and RC parallel circuit was also decreased with increasing both the parameters while AC conductivity was increased in the series. Dielectric frequency response was also studied for the prepared samples and the best match was found with expected results. The Nyquist and Cole-Cole plots revealed the semi-conductive behavior at higher frequency and Mn substitution also yielded the same results. The relative stability of the samples to be used as dielectric materials was also studied using Bode and Nichols plots, and a comparatively high gain margin was observed, well suitable for potential applications in electromagnetic shielding.     

不同浓度的尾砂胶结充填体破坏过程 声发射特性试验研究*

制备了3种不同质量浓度的充填体试件，进行了单轴压缩声发射试验，分析了不同浓度的充填体力学特性，重点研究了试件破坏过程中的声发射振铃计数、声发射累计撞击数与声发射累计能量的比值(r值)、主频及其相对高频信号激增响应系数特征。研究表明：随着浓度的增加，充填体的峰值强度与弹性模量呈增大趋势，充填体中出现的声发射累计振铃计数越多；r值先升高再持续减小到一个较低值，随着外载荷的增加，进入缓慢升高阶段，峰值前均保持在该阶段。充填体破裂前兆信息在声发射信号主频分布中呈现主频段增多现象，表现为由加载初期的1~2个主频段，在临界主破裂时增多到3~5个主频段；且随着浓度的增加，声发射信号主频频段分布越宽，声发射相对高频信号(160~180 kHz)的激增响应系数呈递减趋势。以上特征可为不同浓度的尾砂胶结充填体稳定性监测、预测提供依据。     

Everything you wanted to know about phase and reference frequency in one- and two-dimensional NMR spectroscopy

The fundamental concept of phase discussed in this tutorial aimed at providing students with an explanation of the delays and processing parameters they may find in nuclear magnetic resonance (NMR) pulse programs. We consider the phase of radio-frequency pulses, receiver, and magnetization and how all these parameters are related to phases and offsets of signals in spectra. The impact of the off-resonance effect on the phase of the magnetization is discussed before presenting an overview of how adjustment of the time reference of the free induction decay avoids first-order correction of the phase of spectra. The main objective of this tutorial is to show how the relative phase of a pulse and the receiver can be used to change the reference frequency along direct and indirect dimensions of NMR experiments. Unusual of phase incrementation with non-90° angles will be illustrated on one- and two-dimensional NMR spectra.     

竖直恒温面自然对流边界层不稳定性研究

在无扰动、随机式扰动以及正弦式扰动下,通过对竖直恒温面处状态Ra为1.328×10^9、Pr为6.24的自然对流进行模拟,探索了热边界层的不稳定性和共振强化自然对流换热。结果表明:(1)竖直自然对流边界层上游位置的随机式扰动对热边界层的影响主要体现在稳定阶段;(2)该状态下的竖直自然对流边界层的特征频率为15 067,且相比于无扰动状态,频率为15 067的正弦式扰动能在竖直恒温面处提高5.15%的换热量;(3)在竖直自然对流边界层上游位置加入特征频率的正弦式扰动,竖直恒温面处的局部努塞尔数Nu均出现明显波动,且波动随着边界层高度的增加而增大。